ID48 Installation Matrix Signal Processor

Based on the acclaimed technology, the ID48 offers all of the DSP power and flexibility you will ever need, in a package ideally suited to installation applications.

NST ID48
NST ID48 achterkant

With 4 balanced analogue inputs and 8 outputs with full matrix mixing capabilities, the ID48 gives the flexibility you need to integrate into your system. Compressors are available on every input as well as a high pass filter, 6 bands of parametric EQ and up to 1.3 seconds of delay.

Routing to outputs can be configured to either mix-matrix mode, free-routing or several pre-configured routing options. Flexible channel linking enables quick and easy configuration of common crossover setups or customised configurations as required. Every output channel has high and low pass filters, 8 bands of parametric EQ, up to 1.3 seconds of delay as well as a new limiter designed to offer the best driver protection with the lowest distortion.

The ID48 runs at 96kHz as standard but can be switched into 48kHz mode to take advantage of 48dB/oct output crossover filters and two bands of dynamic EQ on both input and output channels.

The ethernet based PC control software gives you the ability to not only control all the devices on a network but also to store preset memories and configure systems offline.

ID48 Technische Specificaties

Analogue Inputs – 4

Electronically balanced, pin 2 hot
CMRR : >60dB @ 1kHz
Maximum Level : >20dBu
Input Impedance : 10kΩ balanced

Analogue Outputs – 8

Electronically balanced, pin 2 hot
Maximum Level : >20dBu
Source Impedance : <60Ω

Performance

Frequency Response (20Hz to 20kHz) : +/-0.4dB
Dynamic Range : >110dB unweighted (in to out analogue)
THD + N (+10dB @ 1kHz) : 0.0007%
Latency : 0.896ms (in to out, analogue, 96kHz), 1.792ms (in to out, analogue, 48kHz)

Input Processing Features

Soft Knee Compressor
6 Parametric EQs
24dB/Oct HPF
2 bands of Dynamic EQ (48kHz mode)
Gain, Polarity, Delay

Output Processing Features

6 Parametric EQs

Crossover Filters up to 24dB/Oct (96kHz mode) 48dB/Oct (48kHz mode)
2 bands of Dynamic EQ (48kHz mode)
Gain, Polarity, Delay, Limiter

Comms

Remote control via 100Mbps Ethernet, USB Type B
Up to 30 presets may be stored for offline recall

Power Requirements

3-pin IEC input, fused
90-250VAC, 50-60Hz < 40W

Dimensions

Height : 44mm (1.75inch) 1U
Depth : 213mm (8.4 inches)
Width : 482mm (19 inches)

Weight

Net : 2.8kg
Shipping : TBC

Due to continuing product improvement the above specifications are subject to change.

Meer informatie: nstaudio.com/id48/