Full Fat Audio 6000 2-kanaals versterker

FFA dual power dual mono professional audio amplifiers

Ideally suited for driving very high output bass and sub bass loud speakers or high power full range systems. Designed to drive sustained, very high output audio into 2 Ohm loads.

Featuring FFA proprietry Class D PWM amplifiers. These are partnered with FFA high current switch mode PSU technology. Massive bulk storage capacitance per channel ensures continuous high power deliver to the load. The FFA-6000 is dual mono – each channel is totally independent.  FFA dual mono power amplifiers are mains supply power efficient and operate cool even in the most demanding environments. Mechanical construction is tour grade with aluminium used throughout the chassis design. This provides a robust and rigid but lightweight housing for the electronic systems.

Features at a glance

• 2 x 3000 Watts at 2 Ohms

• FFA Class D PWM amplifiers

• Power supply soft start

• High thermal headroom

• Weight – 12kg

• Dual mono power amplifiers

• Clip limiter

• 5 year factory warranty

• Hand constructed and designed in England

• Switch mode power supply

• Power efficient

• 2 Ohm drive

• All aluminium construction

• Dual power supply

Suitable Applications

General purpose bass amplifier used anywhere high quality bass reinforcement is required.

Suitable Applications:  Small low mid or smaller bass cabinets

2×12”, 2x 15”, 2×18” – 2 Ohm drive


Power Ratings FFA – 6000  –   8 Ohms 1000W, 4 Ohms 1800W, 2 Ohms 3000W


Gain 32 dB
THD Typical 0.05 4 Ohm 1kHz THD+N
Frequency Response 20Hz – 20kHz
Controls Power on rocker switch each channel. 40 point Potentiometer each channel
Indicators Power ‘on’ green LED each channel, Signal present green LED, -3dB drive yellow LED, amplifier clip – red signal LED,  amplifier protect due to over temp/clip limiter activated and 3 second mute at power up = red LED
Cooling Rear to front airflow, high CFM fan
Load Protection DC on output, side chain TCA clip limiter circuit
Amplifier Protection Short circuit, current overload, thermal, reactive load stability
Audio  Inputs Neutrik® female XLR with male XLR signal link through per channel
Audio  Outputs Pair of Neutrik® NL4MP-UC speakON® connectors per channel. Each connector has all output poles live 1+, 1-, 2+, 2-. This allows the use of 4 core loudspeaker cable to minimise conductor losses between amplifier and loudspeaker
Power Supply 2 x 20A Neutrik® powerCON® required – one each channel
Power Requirement 220-240 VAC 50-60Hz, 2x16A max per amplifier120V (configured at factory)
Dimensions 2RU 19” rack mount enclosure, H88mm x W483mm x D510mm. Depth includes integral rear rack support ears
Weight 12 kg