Full Fat Audio 6004 4-kanaals versterker

Full power delivery all channels driven simultaneously loaded 4 ohms. Very useful and versatile multimode amplifiers, suited for large scale touring point source or line array systems. Equally suited in less demanding bass applications. Very installation friendly and ideal for bi amp stage monitoring systems or multi point theatre installations. Proprietary high efficiency FFA Class D output stage coupled with high current switch mode supply enables high power delivery even in the harshest environmental conditions.

Features at a glance

4 x 1500 Watts @ 4 Ohms
Power efficient and cool running
Rugged Tour class Aluminium construction
Light weight – 9 kg
FFA Class D technology
High current switch mode power supply
Side chain TCA clip limiter
Hand built and designed in England
Bi amp Neutrik® speakON outputs
Signal Link through
Neutrik® powerCON power input
PSU soft start
5 year factory warranty

Suitable Applications

Bi amplified stage monitor systems, components within large format touring or installation loudspeakers low mid, high mid and HF, 4 ohm drive.

Medium to large full range loudspeakers 10”-15” drivers + 1” 1.5” HF

Low mid, high and HF in larger multi way systems installed or touring.

High power stage monitors 2×12” or 15” +1.5” Medium bass 2×12” 15” or 1×18”


Power Ratings FFA – 6004 – 4 x 800W 8 Ohm, 4 x 1500W 4 Ohm
Gain 32 dB
THD Typical 0.05 4 Ohm 1kHz THD+N
Frequency Response 20Hz – 20kHz +- 0.5dB
Controls 40 Point Potentiometer per channel, power on switch
Indicators signal green = -20dB, signal yellow = -3dB, red signal = clip, signal red protect = over current, low AC mains or 3 sec. mute on power up
Load Protection DC on output, side chain TCA clip limiter circuit
Amplifier Protection Short circuit, current overload, thermal shutdown, high frequency stability circuit
Audio Signal Inputs Balanced Neutrik® Female XLR input connected Pin 1 – GND, Pin 2 – Hot +, Pin 3 – Cold – . XLR Male signal throughput each channel
Audio Signal Outputs Neutrik® speakON each channel. Channels 1 and 3 output speakON utilises 2+ and 2- connection to allow use of 4 core loudspeaker cable for bi amp loudspeaker system for example stage monitor system
Power Requirement 1 x Neutrik® 20A powerCON connector 1 x 16A 230 VAC Circuit. Power range 185V-230VAC120V (configured at factory)
System Cooling High CFM 80mm fan with proportional signal speed control. Rear to front airflow
Dimensions 88mm Height x 483mm Width x 510mm Depth. Includes rear rack support. 19″ rack mount enclosure
Weight 9 kg